Filter
Top Products
E-10
-
Fig. 19
Dirt Cup
Release Button
Fig. 20
Dirt Cup
Release Button
Dirt Cup
Body
CLEANING DIRT CUP
You will need to empty dirt cup when dust reaches the FULL line.•
Turn OFF the vacuum and unplug from electrical outlet.•
Grasp the dirt cup handle and depress button, pull out the dirt cup from •
the body. (Fig. 19)
To empty, remove the dirt cup and hold over trash bin. Push the dirt release •
button and dispose of the dirt. (Fig. 20)
CLEANING & REPLACING FILTER
TO OPTIMIZE THE VACUUM PERFORMANCE YOU SHOULD CLEAN THE
FILTER EACH TIME YOU EMPTY THE DIRT CUP.
1. Lift up the dirt cup cover, rotate and remove the lter protector.
2. Rotate and remove the inner lter. (Fig. 21)
Tap the inner lter on a trash bin to remove the dust from the pleats. (Fig. 22)
NOTE: This inner lter is washable and can be rinsed if you notice a reduction in
vacuum performance (suction). To wash, rst tap lter to remove excess dirt and
dust from pleats. Rinse lter clean with warm water then allow to completely dry
(a minimum of 24 hours) before returning to dirt cup. Use lter: FLTB for inner dirt cup.
r
Tap Gently
Fig. 21 Fig. 22
EXHAUST FILTER CLEANING & REPLACEMENT
Pull out the exhaust lter. (Fig. 23)•
Replace the exhaust lter when it becomes dirty. (Fig. 24) •
Use lter: FLTA for exhaust lter.
NOTE: This lter is washable.
Filter
Filter Frame
Body
Exhaust
Filter
Fig. 23
Fig. 24
NOTE: Replacement parts can be purchased by calling
1.866.603.5900 or by visiting www.germguardian.com.
Dirt Cup Cover
HEPA
Inner Filter
(Located inside
Filter Protector)
Filter Protector
*HEPA Filter is located
INSIDE the green lter
protector. Remove lter
protector to access
HEPA Filter.
*
E-11