Filter
Top Products
COPYRIGHT © APRIL, 2013 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#DM15699 PRINTED IN USA
Introduction
This floating reamer holder is designed to comple-
ment a precise setup—not make up for an inac-
curate one. Before attempting to use the floating
reamer holder, it is critical that every component
used in your setup is adjusted as accurately
as possible. Additionally, alignment adjustments
should be indicated off the bore—not the outside
of the barrel.
Because a floating reamer is not rigidly restrained
like other methods of reamer control, it takes
experience through repetition to use it proficiently.
Before working with an expensive barrel, we
highly recommend practicing on a scrap barrel
until you are familiar with the feel and technique
of using a floating reamer.
Inventory
Operation
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
MODEL T10667/T10668
BALD EAGLE FLOATING
REAMER HOLDER KIT
INSTRUCTIONS
The T10667/T10668 Bald Eagle Floating Reamer
Holder Kit provides excellent accuracy and con-
trol when chambering gun barrels. The holder
compensates for a small amount of misalignment
between the chuck and tailstock, allowing the
reamer enough free movement to remain aligned
with the bore.
This type of holder permits the user to control the
reaming process and release the reamer from
action, preventing damage that can occur to a
barrel when reamers bind.
This reamer holder is only designed for use with
reamers that have properly fit bore bushings or
solid piloted reamers that have the pilot bushing
fitted to the bore. We recommend pre-boring the
chamber a little undersize and using a roughing
and/or a finishing reamer to complete the process.
Description Qty
A. Floating Reamer Holder ............................. 1
B. Round-Nose Dead Center .......................... 1
B
A
Figure 1. T10667 Bald Eagle Floating Reamer
Holder Kit.
Kit Specifications
T10667 Taper ............................................. MT#3
T10668 Taper ............................................. MT#4