Grizzly 1553 Window User Manual


 
Step 1: Cutting Stile and Rail Edges
Make sure the router is disconnected from the
power source. Install the stile and rail cutter.
(C1551 or C1554.) Attach the router to your
router table and adjust the height of the bit
until the top of the bead is
1
16" below the top
of your stile. See Figure A. Adjust the fence
until it is flush with the bearing. (The bearing
can be used without the fence when you are
cutting non-linear shapes such as a curved
arch door rail, however a starting pin should
be employed to help make safe first contact to
workpiece). The workpiece must always be fed
against the cutter rotation and the full depth of pro-
file should be made in one pass to ensure a precise cut. If the window is not to be
painted, a side should be chosen for appearance and marked with a pencil. Before
plugging in the router, set a piece of scrap, the same size as the workpiece, on the
table appearance side up. Lay the edge to be cut firmly against the fence. A hold-
down device such as a featherboard should be used to keep the workpiece secured against the fence. Make a test
cut to ensure that the complete profile is being cut. Adjust, if necessary, and re-test.
Run all of the stiles and rails for the project through the cutter before changing bits to do the rail ends.
INSTRUCTIONS FOR C1550, 1551, 1553, 1554 and
C1552, C1555 SASH SETS
Designed specifically for archi-
tectural window construction,
the Model C1550-C1554
Window Sash Sets offer excel-
lent quality for creating beaded
and ogee window trim stock.
The C1550/C1551 (also sold as
C1552) combination produces a
bead style finish. The
C1553/C1554 (also sold as
C1552) combination produces the classic Ogee finish. Fitted with precision guide bearings, these bits are capable
of being used with a hand held or table mounted router. Using a table mounted router will give best results. For
maximum operating efficiency, a router rated at 1 horsepower or larger is recommended. The maximum frame
thickness: 1
3
8".
Note: These instructions and drawings are intended for explanation and clarification purposes only as they relate
to this particular router bit. Apply all safety rules and measures pertaining to router operations and your specific
operation. Refer to the owner’s manual supplied with your router and router table for specific warnings and instruc-
tions before proceeding with equipment operations.
Router Table
Fence
1
16''
Outer Side
© May 2003 Grizzly Industrial, Inc.529003622
These router bits have sharp
edges. use care while
removing the waxy protec-
tive coating. Never turn on
the router with the protective
coating still on the bit.
•Failure to follow theSE
guidelines will result in seri-
ous personal injury.
•ALWAYS WEAR ANSI
APPROVED EYE AND EAR
PROTECTION WHEN USING
THIS BIT.
•The use of a router table is
strongly recommended.
•Never feed lumber with the
rotation of the bit.
•Follow the safety guidelines
set forth by the manufactur-
er of the router and router
table.
Unplug router before
installing or adjusting
bit.
Keep all guards and anti-
kickback devices in place.
Double check bit to insure
nut is tight and bit is tight
and secure in spindle.
Always inspect lumber and
other wood materials for
cracks, knots, or other
imperfections that could
cause bit or lumber to kick
or shatter while milling.
C1550/C1553
C1551/C1554
Top of Bead
Figure A