Filter
Top Products
Pressure Drop Data SMD-203
This pressure drop testing was conducted in accordance with AMCA Standard 500-D using the three congurations shown. All
data has been corrected to represent standard air at a density of .075 lb/ft
3
(1.201 kg/m
3
).
Actual pressure drop found in any HVAC system is a combination of many factors. This pressure drop information along with an
analysis of other system influences should be used to estimate actual pressure losses for a damper installed in a given HVAC
system.
AMCA Test Figures
Figure 5.3 Illustrates a fully ducted damper. This conguration has the lowest pressure drop of the three test congurations
because entrance and exit losses are minimized by straight duct runs upstream and downstream of the damper.
Figure 5.2 Illustrates a ducted damper exhausting air into an open area. This conguration has a lower pressure drop than
Figure 5.5 because entrance losses are minimized by a straight duct run upstream of the damper.
Figure 5.5 Illustrates a plenum mounted damper. This conguration has the highest pressure drop because of extremely high
entrance and exit losses due to the sudden changes of area in the system.
5D 6D
5D
D
4 (W) (H
)
3.14