Graco 9047 Boiler User Manual


 
Side mesh
panel
Canopy mesh
Front mesh
panel
5
364-4-98
6 8
7
To Set Up and Use Your Canopy
When properly used, the canopy provides shade for your
child. However, your child may be warmer inside the play
yard than in a shaded area outside the play yard.
To help prevent build-up of heat inside the play yard and to
avoid over-heating your child:
!
Turn canopy mesh away from the sun. Keep entire
mattress shaded from sunlight at all times.
!
Keep play yard well ventilated:
!
Always keep the front mesh panel and one side mesh
panel of the play yard open.
!
Never cover the canopy mesh.
!
Never use canopy with an add-on bassinet in the
play yard.
As always, use good judgment to protect your child from
exposure to heat which can lead to serious injury or death.
NEVER leave your child unattended.
ALWAYS keep your child in view.
Side mesh
panel
Canopy mesh
Front mesh
panel
Step 1.
Unfold the tubing and slide
the three sections together to
form one long tube. The
elastic cord in the tubing will
hold the pieces together.
Step 2.
Slide the long tube into the
tunnel in the canopy until
both ends stick out of the
tunnel 3 or 4 inches. The
tunnel is on the shiny side
near the netting.
Step 3.
Push the tube ends into
the corner brackets on the
Pack N Play. Tube end caps
will snap into place in the
brackets.
NOTE: The mesh side of
the canopy goes on the
same side of the unit as the
brackets. The shiny side
goes on the inside of the unit.
To remove canopy, first
grasp tube firmly so that it
will not spring out. Then push
in on end caps to release
them from brackets and pull
tube ends up.
Step 4.
Pull the back corners of the
canopy over the back corners
of the Pack N Play and fasten
the VELCRO
®
squares located
on the ends of the top rail and
back corners of the canopy.
Canopy
Tubing
Accessory Features
BACK FLAP:
You can raise back flap if
desired.
Unfasten VELCRO
®
straps at
bottom of flap. Roll flap up.
Fasten in place with snap
loops at top.
TOY BAG:
Toy bag snaps on end of
unit. Maximum weight 2 lbs
(0.9 kg).
DO NOT machine wash or dry
in a dryer. DO NOT dry clean.
Spot clean with a damp cloth
and a mild detergent. NO
BLEACH.
WHEELS:
To apply the wheel locks,
push DOWN on the lever.
To release the wheel locks, lift
UP on the lever.
Step 5.
To help prevent build-up of heat inside the play yard
and to avoid over-heating your child:
!
Turn canopy mesh away from the sun. Keep entire
mattress shaded from sunlight at all times.
!
Keep play yard well ventilated:
!
Always keep the front mesh panel and one side
mesh panel of the play yard open.
!
Never cover the canopy mesh.
Maintenance of Canopy:
DO NOT machine wash or dry in a dryer.
DO NOT dry clean. Spot clean with a damp cloth and
a mild detergent. NO BLEACH.
Push in, then up
Step 4.
Hold one end of the unit up and
push the center of the floor
down.
At first your Pack N Play may
be like a new pair of shoes.
You may need to break it in by
slightly stretching the netting
and fabric. If the center does not
stay down, place some weight
(several books) in the center of
the unit and let it stand
overnight.
Step 5.
Do not use your Pack N Play
without the mattress provided
by Graco.
Place the mattress into your
unit with padded side up.
Always use your unit with
mattress installed soft side up.
Slide the two VELCRO
®
straps
through slots in bottom of
Pack N Play and fasten to
VELCRO
®
on underside. This will
prevent mattress from moving.
Make sure the mattress is
installed properly before
placing your child in the Pack N
Play.
Your Pack N Play is ready to
use.