Filter
Top Products
Setup Screens
Setup Screen 1
2
Use this screen to set your modbus preferences.
Figure 38 Setup Screen 12
Setup Scre
en 12 Key
Enter the screen.
For systems with multiple pumps and
one display, select the desired pump (1
to 8), using the pull-down menu.
Control location. Select local or
remote
control from the dropdown
options. Setting applies to the selected
pump only.
Enter or change the Modbus node ID.
Value is between 1 and 247. Each
pump requires a unique node ID, which
identifies that pump if more than one
pump is connected to the display..
Select serial port baud rate from the
dropdown options: 57600 or 115200.
This is a system-wide setting.
Press to accept the selections.
Exit
data editing.
Figure 39 Select Local or Remote Control
Figure 40 Se
t Modbus Node ID
Figure 41 Set Baud Rate (Bits Per Second)
NOTE:The following are fixed modbus settings,
which cannot be set or changed by the user: 8 data
bits, 2 stop bits, no parity.
26 3A2527E