Filter
Top Products
Drive and Bearing Housing
3A0246C 5
Drive and Bearing Housing
Removal
1. Perform Pressure Relief Procedure, page 4.
2. Remove Power Module, see page 7.
3. Remove Pump, page 8.
4. Remove four screws (40) and lift motor shroud (98)
off of motor.
5. Disconnect three wire harnesses (see Wiring
Diagrams, pages 34-36).
6. Remove two screws (5b) from underneath motor
base plate. Lift and remove motor/pump assembly
from power module.
7. Loosen four screws (19) on pump housing, and
remove bearing housing (9) from motor.
8. Remove three screws (5c) on motor (8a). Remove
motor (8a) from drive housing (5a).
NOTICE
Do not drop gear cluster (17a) when removing drive
housing (5a). Gear cluster may stay engaged in motor
front end bell or drive housing.
ti15624a
98
40
ti11734a
5b
ti15630a
19
9
ti11735a
5a
5c
8a