Filter
Top Products
10
12. Lubricate weep seal (36). Place, weep seal (36), and pressure ring (36A) into
the seal sleeve (35). Assemble the o-ring (35A) onto seal sleeve and
lubricate.
14. Press seal sleeve assembly into
the manifold and seat firmly. Put
the support ring (41) on plunger
with v-side facing the manifold.
15. Place entire manifold/seal sleeve
assembly over the studs and
push firmly until seated against
the crankcase.
18. Replace plug with o-ring (48, &
48A) and tighten to 160 ft.-lbs.
13. Place support ring (41) and
v-sleeves (40) into valve
casing (43).
17. Next, place valve assemblies
(46A) into manifold after first lu-
bricating the o-ring (44A). Seat
firmly into manifold.
16. Tighten hex nuts (49A) in a
crosswise pattern (shown
above) to 60 ft.-lbs.
19. Fill crankcase with approximately
116 fluid ounces of Giant oil or
equivalent SAE 90 industrial gear
oil and check oil level of the
crankcase with the dipstick.
Proper level is center of two lines.
Reinstall your Giant LP pump
into your system.
Contact Giant Industries or your local distributor for maintenance
of the gear end of your pump. Phone: 419/531-4600
Contact Giant Industries for service school information. Phone: (419) 531-4600
36A 36 35 35A 39
6
4 2
7
8
1 3
5