Filter
Top Products
U.S. (Metric)
Volume .............................................................Up to 56.8 GPM ...... (215 LPM)
Discharge Pressure .........................................Up to 3770 PSI ........ (260 bar)
Speed ...............................................................Up to 580 RPM ....... 580 RPM
Inlet Pressure ...................................................Up to 29 PSI............ (2.0 bar)
Plunger Diameter.............................................1.89” ........................ 48mm
Plunger Stroke .................................................2.83” ........................ 72mm
Crankshaft Diameter........................................2.76” ........................ 70mm
Key Width........................................................0.55” ........................ 14mm
Crankshaft Mounting......................................................................... Either side
Shaft Rotation .................................................................................... Top of pulley towards manifold
Temperature of Pumped Fluids........................Up to 86
o
F .............. (30
o
C)
Inlet Ports .......................................................................................... (2) 3” BSP
Discharge Ports ................................................................................. (2) 1-1/4” BSP
Weight ..............................................................705 lbs./ ................... (320kg)
Crankcase Oil Capacity ...................................3.3 Gal. .................... (12.5 liters)
Fluid End Material............................................Nickle plated Spheroidical Cast Iron
Specifications
Model GP8048
Consult the factory for special requirements that must be met if the pump is to
operate beyond one or more of the limits specified above.
HORSEPOWER RATINGS:
The rating shown are the power
requirements for the pump. Gas
engine power outputs must be
approximately twice the pump
power requirements shown above.
We recommend a 1.15 service
factor be specified when selecting
an electric motor as the power
source. To compute specific pump
horsepower requirements, use the
following formula:
GPM X PSI
= HP
1450
6
GP8048 HORSEPOWER
REQUIREMENTS
RPM GPM 1000 PSI 2000 PSI 3000 PSI 3770 PSI
300 29.4 20.3 40.6 60.8 76.4
400 39.2 27.0 54.1 81.1 101.9
500 49.0 33.8 67.6 101.4 127.4
580 56.8 39.2 78.3 117.5 147.7
SPECIAL NOTE:
The theoretical gallons per revolution (gal/rev) is 0.0979.
To find specific outputs at various RPM, use the formula:
GPM = 0.0979 x RPM