Filter
Top Products
6
Volume ....................................................46.5 GPM .................................. 175.9 L/min
Discharge Pressure ................................1740 PSI .................................... 120 Bar
Speed .......................................................................................................... 800 RPM
Inlet Pressure (max.) ..............................145 PSI...................................... 10 Bar
Plunger Diameter....................................1.77” .......................................... 45mm
Plunger Stroke ........................................1.89” .......................................... 48mm
Crankshaft Diameter ..............................1.78”.......................................... 45mm
Key Width ...............................................0.47” .......................................... 12mm
Crankshaft Mounting .................................................................................. Either side
Shaft Rotation ................................................................................ Top of pulley towards manifold
Temperature of Pumped Fluids (max). ...140
o
F ........................................ 60
o
C
Inlet Ports ................................................................................................... (2) 1-1/2" BSP
Discharge Ports .......................................................................................... (2) 1" BSP
Weight .....................................................309 lbs. ...................................... 140 Kg
Crankcase Oil Capacity ..........................1.1 Gal. ...................................... 4.2 Liters
Fluid End Material....................................................................................... Stainless Steel
Specifications
Model GP6145-4000
Consult the factory for special requirements that must be met if the pump is to
operate beyond one or more of the limits specified above.
HORSEPOWER RATINGS:
The rating shown are the power requirements for the pump. Gas engine power outputs must
be approximately twice the pump power requirements shown above.
We recommend a 1.15 service factor be specified when selecting an electric motor as the
power source. To compute specific pump horsepower requirements, use the following
formula:
HP = (GPM X PSI) / 1400
GP6145-4000 HORSEPOWER
REQUIREMENTS
RPM GPM 500 PSI 1000 PSI 1500 PSI 1740 PSI
400 23.3 8.3 16.6 24.9 28.9
500 29.1 10.4 20.8 31.1 36.1
600 34.9 12.5 24.9 37.4 43.3
700 40.7 14.5 29.1 43.6 50.6
800 46.5 16.6 33.2 49.8 57.8