Gianni Industries DG-27 Door User Manual


 
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG25 Ver. B Publish:2008.08.01 Page: 3/ 3
Changing the Master codes:
Enter the Programming mode, Enter「*000Followed by the new 5 digit master
codebeepenrolledEnter # to exit from the programming mode, or
program other operating.
Master Code reset to Factory 12345
Insert the jumper P1Æ 1-2 positionÆ5 audible beepsÆReset successfulÆ Return
Insert the jumper to 2-3 position.
5. Wiring diagram:
1
2
3
Fail-Secure
Locking Device 1
Fail-Safe
Locking Device 2
Power Supply
Power Supply
Contact door reed switch
This reed switch is used
to reset the re-locking time
to 0 second when the door
is moved.
(Using N.O. contact in case
of door closed,
changeover to N.C. When
door is moved)
Master Code
reset to
Factory 12345
「」
Push Button 2
Push Button 1
Note:
The suggested wire gauge is #22~26 AWG.
The varistor or diode must be connected across the lock terminal (electromagnet...)
operated by the device. The vartistor controls the overload produced by the strike coil
(EMP).
Egresses switch should be N.O. type.