Genie GPOWER 900 Garage Door Opener User Manual


  Open as PDF
of 24
 
WARNING
•Useextremecautionwhenworkingfromaladderorstepstool.
•Whenreplacinglightcover,makesurewiresarenotpinchedor
near moving parts.
Maintenance and Adjustments
6
REGULAR MAINTENANCE (continued)
• Screwdrivemodels:VerifyshuttlereleaseleverisinENGAGED
(UP) position (pull release handle toward opener and let go)
• Chain/beltdrivemodels:Verifybulletisengagedtocarriage.
Pull/release cord down and back towards opener and let go.
– Operate door using a remote or wall console.
– Door will re-attach itself to carriage assembly.
CORRECTIVE MAINTENANCE
Changing Light Bulbs
1. Disconnect power to door opener.
 • Openpowerheadlightcover.
 • Removelightbulb(s).
 •Replacelightbulb(s).
– DO NOT use light bulbs with greater than 100 Watt rating,
PowerLift
®
900, GPower
™
900
require light bulbs of no more
than 60 watts. Compact CFL's may also be used.
– Close powerhead light cover.
2. Reconnect power to door opener.
•Testlightoperation.
Reset Open/Close Travel Limit
Performing all eleven (11) Limits/Force setting steps (see pages 6-8)
erases previous Limits/Force settings.
NOTE: The opener will not close the door automatically unless the
Safe-T-Beam
®
System is installed and Limits are programmed.
Disengaging and Engaging Carriage/Bullet
Remote Battery Replacement
Replace remote battery with a CR 2032 coin cell battery.
1. Open remote case using a washer or coin that fits into the slot at
top of remote.
2. Replace battery.
3. Align components and snap case
closed.
(continued next page)
EngagedEngaged
OpenerOpener
Disengaged
Disengaged
EngagedEngaged
OpenerOpener
Disengaged
Disengaged
Screw DriveScrew Drive Belt/Chain DriveBelt/Chain Drive
EngagedEngaged
OpenerOpener
Disengaged
Disengaged
EngagedEngaged
OpenerOpener
Disengaged
Disengaged
Screw DriveScrew Drive Belt/Chain DriveBelt/Chain Drive
To engage bullet to carriage,
pull the release handle down and
toward the opener.
To disengage bullet from carriage,
pull relaese handle down and
toward the door.
To engage shuttle to carriage,
pull down and toward the opener.
To disengage shuttle from carriage,
pull down on relaese hanfle
.
17
G999-393 Manual-ScrewBeltChain-EN indd 17 7/13/12 10 17 AM
 previous next