Filter
Top Products
6
Installation
Beverage Center & Wine Chiller
Remove all packing material and tape.
Tools and materials required:
• #2 Phillips screwdriver
Parts List:
A. Stainless tubular handle
B. 2 Handle standoffs
C. 3 Screws for mounting handle standoffs
(2 required, 1 extra)
D. 3 Set screws (2 required, 1 extra)
E. 3/32" Allen wrench for set screws
F. 4 U-Clips
G. 4 Leveling legs
H. GE Monogram nameplate
I. 8 Plug buttons
J. Hinge Shims
K. 2 Screws for light trigger hole
Remove the
Packaging
1
Step
Install
Handle
2
Step
Note:
Consider door swing direction. If you wish to change door
swing, complete the instructions shown on page 5 before installing
the handle.
• Place handle standoff against the top screw hole
in the door. Position the standoff so that the
small screw hole points toward the floor.
•Drive screw through the standoff and into the
door. Do not tighten.
•Install bottom standoff. Do not tighten.
•Place handle to standoffs so that handle mount-
ing posts are inserted into the standoffs. The
handle should fit into the curved shape of the
standoff. Again, the set screw hole should be
pointing downwards.
•Remove the handle and tighten standoffs to
door.
•Place handle to standoffs and install set screws
through the bottom of standoffs using the allen
wrench provided.
•The handle should be tight against the standoff.
•Save the allen wrench for future use.
Screw
Allen Wrench
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K
CAUTION: Small objects are a choke
hazard to children. Remove and
discard any parts not used.
PRUDENCE – Les petits objets
peuvent étrangler les enfants. Il faut
jeter toutes les pièces qui ne sont pas
utilisées.