Filter
Top Products
Window Installation Instructions
INSTALL THE CASE
IN THE WINDOW
Carefully slide the case into the window and
center the case. Lower the window behind
the top mounting rail. Pull the bottom of the
case forward so that the bottom mounting
rail is tight against the back of the window
stool. Mount the case to the window sill using
4 type E screws. Drill pilot holes, if necessary.
Make sure the bolts
and nuts are all of the
way in both the left
and right V-supports.
Position the V-supports
on the case bottom so that
they will be near the outside
wall. Attach a V-support to
each side of the bottom of
the case using type C
screws, 3 on each side.
Use a wood block (obtained
locally) between the leveling
bolts and the wall if the wall
is weak or if the weight of the
air conditioner falls between
the studs in the wall.
Adjust the leveling
bolts and nuts against
the outside wall so
that the case has a
slight tilt to the outside.
Tighten nuts with an
adjustable wrench. Use
a level; no more than a
1/2 bubble will be the correct case slant to the
outside.
E
D
C
B
A
6
INSTALL SUPPORT BRACKETS
AND THE FOAM TOP WINDOW
GASKET
Drill pilot holes and attach the support
brackets with two type D screws, one on
each side.
Cut the foam top window gasket to the
window width.
Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
C
B
A
7
11
4 type E screws
Stool
Bolt and nut
V-support
INSTALL THE CASE
IN THE WINDOW
(cont.)
Extend the left and right accordion panels
to the vertical window sashes. Drill pilot
holes and attach the top and bottom
corners with 4 type D screws.
F
6
Type D
screw
Type D
screw
Type D
screw
Top mounting rail
Type D
screw