Filter
Top Products
3
IOWA RESIDENTS ONLY.
Store or Seller’s name
Address
City State Zip Code
Telephone
Seller’s signature
Customer’s signature Date
Cartridge Replacement Procedure
Remove the pitcher lid cover and the monitor cover from the
pitcher handle by lifting straight up.
Pull out the filter cartridge and dispose of used cartridge.
Follow steps 1 through 5 in the Start Up Procedures section.
Press and hold the reset button for 5 seconds.
Press the monitor cover back into place on the handle.
Replace lid cover.
6
5
4
3
2
1
Replacement Cartridge Filter
FXPL3D or FXPL3CAD – 3-pack replacement filters – $20–$30
For replacement parts and pricing in the U.S.: 800.626.2002.
In Canada: 866.777.7627.
Filling the Pitcher with Tap Water
When you are adding tap water to the filtration pitcher, you do not
need to remove the lid cover.
Use thumb to press down the
thumb tab on the sliding lid on
the lid cover. Then slide back.
Fill pitcher with cold tap water.
Slide the sliding lid back into
place.
Water will be ready to drink in a
few minutes.
NOTE:
Keep pitcher filter refrigerated at all times. After 3 to 4 days,
replace unused water with fresh, clean water.
4
3
2
1
Battery
Cover
Reset
Button
Indicator Light
The filtration pitcher is equipped with a blue indicator light
on the handle.
• Blinks 3 times – time to change the filter.
• Blinks 9 times – time to change the filter and battery.
The filter needs to be replaced approximately every two months
and the batteries need to be replaced every six months.
Indicator Light
Monitor
Cover