Filter
Top Products
SmartCom Room Station
Installation Instructions
2
Cable testing
Verify the installation by doing a cable test for each cable run.
Keeping documentation of each test will protect you if a
damaged cable is discovered after the sheetrock has been
installed. Consult the ANSI EIA/TIA-570-B testing section for
the following testing details:
• Continuity testing
• Near-end crosstalk testing
• ANSI EIA/TIA-570-B standard testing
Installer programming
When you power up the room station, it will show a station
disabled message. To get the room station up and running, you
must add the station address. The address cannot be one that is
already used and the room station address must match the audio
zone address.
To access installer programming, press the top two control
buttons on the room station (Music and Intercom) simulta-
neously.
The Setup menu will display with the following menu options,
(turn the selection knob to navigate to an item and press the knob
to select it):
Room station address. Use this option to select a room
station address.
Display settings. Use this option to set the following
settings:
• Screen timeout
• Backlight timeout
• Backlight level on
• Backlight level off
• LED level on
• LED level off
• Contrast level
Intercom settings. Use this option to set the following
settings:
• Edit station name
• Talk timeout
• Hand free enabled
• Call blocking
• Chime volume
Audio settings. Use this option to set the following
settings:
• Master mode enabled
• Volume limit
• Intercom over speakers
• Edit source
Door enabled. The door enabled feature has a factory
default of No. Use this option to toggle the feature to Yes if
your installation includes a door strike and this room station
controls the door.
System info. Use this option to view system information
such as hardware and software revision numbers.
Restore defaults. Use this option to restore settings to the
factory defaults.
Exit menu. Use this option to exit the Setup menu.
Refer to the room station user documentation for more program-
ming information.
FCC compliance
This device complies with part 15 of the FCC rules. Operation is subject to the
following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Specifications
Power 100 mA powe supplied by the intercom hub
Operating temperature 0 to 120°F (-17 to 48°C)
Technical support
Toll-free: 888.GESECURity (888.437.3287 in the US, including Alaska and Hawaii; Puerto Rico; Canada).
Outside the toll-free area: Contact your local dealer.
www.gesecurity.com