Filter
Top Products
10
Customer Service Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Customer Service Troubleshooting Tips
Installation Instructions
Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips
Installation Instructions
Safety Instructions
Operating Instructions
Window Installation Instructions
Install the Case in the Window
Open the window and mark the centerline
on the stool.
Place the sliders, one on each side, into the top
retainer bar.
Carefully place the case in the window and
align the center of the bottom tie bar with the
centerline on the window stool. Do not release
your grip on the case until the window is in its
final position.
Close the window until it touches behind the
top retainer bar. Do not close the window so
tightly that the sliders cannot move.
Attach the case side seals on the outside of the
case by using three 3/8″ screws on each side.
Secure the case through the case track into the
window stool on each side, using two 1″ screws.
F
E
D
C
B
A
Remove the Air Conditioner from the Case
Remove the air filter. Lift the top of the filter
and gently pull it up.
Remove the 2 screws and lift off the grille.
Keep these screws to reattach the grille later.
Remove one screw from each side of the case.
Keep these ground/anti-theft screws so they
may be replaced at the end of the installation.
Slide the air conditioner from the case by
grasping front flange of the evaporator cover
and pulling forward while bracing the case.
NOTE: The air conditioner is very heavy. It may
require two or more people to remove it from
the case.
D
C
B
A
3
4
Remove screws
Mark centerline
Top retainer bar
Bottom tie bar
Slider
Secure to stool
Attach
side seals
Remove
screw
Grasp front
flange and
pull forward
Air conditioner
Evaporator
cover
Case