Filter
Top Products
Window Installation Instructions
11
INSTALL THE CASE
IN THE WINDOW
Carefully slide the case into the window
and center the case. Lower the window
behind the top mounting rail. Pull the
bottom of the case forward so that the
bottom mounting rail is tight against the
back of the window sill. Mount the case
to the window sill using 6 type B screws.
Drill pilot holes, if necessary.
Thread a type C bolt about 1/2 of the way
into the outer face of the shortest angle
of each V-support.
Position the V-supports on the case
bottom so that they will be near the
outside wall. Attach a V-support to each
side of the bottom of the case using type
A screws, 4 on each side.
7
Type C bolt
V-support
6 type B screws
Sill
A
B
C
INSTALL THE CASE
IN THE WINDOW
(cont.)
Use a wood block (obtained locally)
between the leveling bolts and the wall
if the wall is weak or if the weight of the
air conditioner falls between the studs
in the wall.
Adjust the leveling bolts against the
outside wall so that the case has a slight
tilt to the outside. Tighten nuts with an
adjustable wrench. Use a level; no more
than a 1/2 bubble will be the correct case
slant to the outside.
Extend the left and right accordion panels
to the vertical window sashes. Drill pilot
holes and attach the top and bottom
corners with 4 type B screws.
7
Type B
screw
Type B
screw
Type B
screw
Top mounting rail
Type B
screw
D
E
F