GE AHH40 Dehumidifier User Manual


 
Consumer Support
Troubleshooting Tips Operating Instructions Safety InstructionsTroubleshooting Tips Care and Cleaning Safety InstructionsOperating Instructions
6
There are 2 ways to remove collected water:
Use the bucket. When the bucket is removed,
the unit will shut off. Empty and replace the
bucket.
IMPORTANT: Do not use the drain tube if using
the bucket to collect water. When the drain tube
is connected, water will flow through it onto the
floor instead of into the bucket.
NOTES:
Do not remove the bucket while the
dehumidifier is operating or if it has just
stopped operating. This might cause some
water to drip from the drain pan.
The bucket must be in place and securely
seated for the dehumidifier to operate.
Use a hose. Water can be automatically
emptied into a floor drain by attaching the
unit’s drain tube with nozzle and a garden
water hose (not included).
1. Remove the bucket from the front of
the unit.
2. Remove the plug cover from the back of
the unit and store it in a safe location.
3. Insert the tube through the hole in the
back of the unit and securely press it onto
the connector on the front of the unit. Push
the tube around the front connector until
the nozzle is flush with the back of the unit.
4. Secure the nozzle to the back of the unit
with the two screws provided.
5. Cut (as needed) and thread a garden hose
(not supplied) onto the nozzle and lead it
to the floor drain.
6. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely
seated for the dehumidifier to operate.
Always make sure the water bucket is locked into place on the dehumidifier.
Water Level
The dehumidifier will turn off automatically
when the bucket is full, or when the bucket is
removed or not replaced in the proper position.
The bucket must be replaced in the proper position for
the dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the
proper position.
Using the dehumidifier.
Removing Collected Water
NOTE: Support bucket with
both hands when emptying.
Insert tube through
hole in back of unit.
Back of unit
Front of unit
Back of unit
Firmly press the tube
onto the front connector.
Back of unit