Filter
Top Products
5
ge.com
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
Consumer Support
Troubleshooting TipsOperating Instructions
Safety Instructions
Installation Instructions
Use the COOL mode with HIGH (F3), MED (F2) or
LOW (F1) fan for cooling. Use the Increase ▲ /
Decrease ▼ pads to set the desired temperature
between 60°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on and
off to keep the room at the set level of comfort. Set
the thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned
on while set to a COOL setting or if turned from a fan
setting to a COOL setting, it will take approximately
3 minutes for the compressor to start and cooling to
begin.
Cooling Descriptions
For Normal Cooling—Select the COOL mode and
HIGH (F3) or MED (F2) fan with a middle set
temperature.
For Maximum Cooling—Select the COOL mode
and HIGH (F3) fan with a lower set temperature.
For Quieter & Nighttime Cooling—Select the
COOL mode and LOW (F1) fan with a middle set
temperature.
NOTE: If you switch from a COOL setting to OFF or to
a fan setting, wait at least 3 minutes before switching
back to a COOL setting.
COOL Mode
Use the FAN at HIGH (F3), MED (F2) or LOW (F1) to
provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
FAN Mode
The side-to-side air direction is adjusted by moving
the lever to the left or right.
Air Direction—Side-to-Side
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
NOTE: For best cooling efficiency, angle the louvers up.
Air Direction—Up and Down