Filter
Top Products
REMOVE AIR CONDITIONER FROM CASE
Remove the front grille. See the Care and
Cleaning section.
Find the locking plate located on the front
left side.
Remove the screw and the locking plate to
unlock the air conditioner.
Remove and discard the shipping screw
on the back of the air conditioner to allow
removal of the air conditioner from the
case.
Pull the bottom corners of the air
conditioner and slide it out of the case.
Remove the three shipping pads inside the air
conditioner next to the compressor.
Remove the rear grille that is taped to the back
of the case. Remove the packet of screws taped
to the back of the grille. While holding the grille
at a 45° angle, insert it into the clips at the top of
the case and push the bottom in. Keep slight
upward pressure on the grille until it fits flush
with the bottom of the case.
15
STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt towards the outside and will
keep it from draining properly. To adjust for this,
attach a piece of wood to the stool.
WOOD PIECES:
WIDTH: 2″
LENGTH: Long enough to fit inside the window
frame.
THICKNESS: To determine the thickness, place a
piece of wood on the stool to make it 1/2″ higher
than the top of the storm window frame.
Attach securely with nails or screws provided by
the installer.
2
1/2″ higher
than
frame
Storm
window
frame
Wood
Stool
Sill
3
A
B
C
Locking
plate
Remove
screw
D
Remove
screw
E
F
If attaching the grille
from the outside of
the case use the 2
long screws.
If attaching the grille
on the inside of the
case use the 2 short
screws.
G
Clips
Insert the 2 long screws on
the outside
Insert the 2 short screws
on the inside
Installation Instructions
Remove
shipping
pads