Filter
Top Products
4
■ To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
■ The remote control signal has a range of up
to 21 feet.
■ Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
■ Make sure batteries are fresh and installed
correctly–see the
Care and Cleaning
section.
About the controls on the air conditioner–models with touch pads.
Features and appearance will vary.
Air Conditioner Controls Remote Control
ON/OFF
Turns air conditioner on and off.
Display
MODE
Use to set the air conditioner to
COOL
or
FAN
.
Increase
▲
/Decrease
▼
Pads
Use to set temperature when in
COOL
mode.
FAN
Use to set the fan speed at
LOW, MED
or
HIGH
.
CIRCULAIRE
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn
ON
until the desired air direction is obtained,
then turn it
OFF
.
ENERGY SAVER–
Controls the fan.
ON–
The fan and compressor cycle on and off.
This results in wider variations of room
temperature and humidity. Normally
used when the room is unoccupied.
Note: The fan will continue to run for a short
time after the compressor cycles off.
OFF–
The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at
OFF
in order to use
the fan settings (on the mode control).
TIMER
ON–
When the air conditioner is off, it can be
set to automatically come on in 1 to 24
hours at its previous setting. Each touch
will set the time in hours.
OFF–
When the air conditioner is on, it can be
set to automatically turn off in 1 to 24
hours. Each touch will set the time in
hours.
To cancel the timer, press the
TIMER
pad
until the display time disappears.
SLEEP
Press to set the air conditioner to run for 8
hours before it automatically shuts off.
When the
SLEEP
pad is pressed,
SLEEP
scrolls
across the display for approximately 15
seconds, then shows the time remaining.
One hour after the sleep timer is set, the set
temperature will automatically increase 1°F.
To cancel the sleep mode, press the
SLEEP
pad a second time.
Note: The sleep timer will be cancelled if the
TIMER, ENERGY SAVER or MODE pad is pressed.
Remote Control Signal Receiver
Remote Control
Consumer Support Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation Instructions
Low
Fan
On
Med
Fan
On
High
Fan
On
CIRCULAIRE
On
ENERGY
SAVER On
Cool
Mode On
Fan
Only
On
Timer
On