GE 45602 Indoor Furnishings User Manual


 
Please Note: Z-Wave home control networks are designed to work
properly alongside 802.11 wireless computer networks, Bluetooth
and other 2.4GHz or 5.8GHz devices. Some baby cams, wireless video
devices and older cordless phones using the 900MHz frequency range
may cause interference and limit Z-Wave functionality. Many 900MHz
products have a switch to select channel “A” or “B”. You may find that
one of these channels will cause less interference than the other.
Key Features:
- One Z-wave controlled AC outlet for standard incandescent
lighting
- Remote ON/OFF and Brightness control via the Z-Wave
controller
- Manual ON/OFF and Brightness control with the front panel
pushbutton
- Load-Sensing turns the light ON if the switch on the
connected light is used instead of the remote or pushbutton
on the Z-Wave module
- One Always-ON pass-through AC outlet
- Space efficient design
- Does not block the lower outlet when plugged in to the upper
outlet of a duplex wall receptacle. (This assumes that the
duplex receptacle is mounted with the ground pin down.)
- Plugs and cords for connected devices route to the side
allowing close placement of furniture
- Grounded 3-wire power connection for safety