Filter
Top Products
Problem Possible Causes What To Do
The air is not always
The heat pump is not • This is normal. The heat pump will produce warm air
cool or hot during
producing hot air. but not as hot as air produced when the higher-cost
operation
electric heat is used.
The fan switches may be • This causes the fan to blow room temperature air
set at continuous fan. even when the compressor or heater cycles off.
The continuous air movement provides better
overall temperature control in the cool mode.
• There is one switch for cooling and one switch
for heating.
The air does not feel
The heat pump alone • Use the Electric Heat Option. This turns off the
warm enough during
produces air that feels heat pump and warms with electric heat only.
heating operation
cooler than desired.
NOTE: Use of this option will result in increased energy
consumption.
The unit is not
The fan dip switch may • See the
Auxiliary Controls
section.
blowing out air
be set to
CYCLE
.
The electric heating
The power cord is not • Remove the room cabinet and make sure that the
feature does not work
firmly attached. yellow connector on the end of the power cord is
firmly engaged.
Temperature display
The compressor may • Set the operation control to
STOP
and then restart
flashes
have failed. the unit. If the flashing light reappears within
30 minutes, call for service.
Before you call for service… ge.com
21
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support