Filter
Top Products
ON: Add a jumper to a location
OFF: Remove jumper from a location.
4. Remove or add the jumpers to match the table.
5. Store unused jumpers as shown.
Parking the jumper on an open set of pins. The two jumpers on the left are in the parked
position.
Setting The House Security Code
Each chime component has jumpers for setting the house security code.
In most cases you will not need to change the factory settings for the
security code. If your chime activates intermittently or does not work at all,
you may be able to solve the problem by changing your security code.
Adding Additional Buttons
When adding a pushbutton to an existing system, you need to check the security code
on the existing chime and match the new pushbutton to that code.
The chime and pushbutton must be set to the same house security code for the
combination to operate together.
Note
: The push button has 3 additional jumpers that are used to set the chime tune
that will play. The chime tune jumpers do not affect the house security code.