GE 106766 Vacuum Cleaner User Manual


 
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). The
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
Afin de réduire le risque de choc électrique, cet appareil est muni d’une fiche polarisée (une des lames est plus
large). Cette fiche ne peut étre insérée dans une prise polarisée que d’une seule façon. Si la fiche ne peut étre
insérée dans la prise, retourner la fiche. Si la fiche ne peut toujours pas étre inséree dans la prise, faire installer une
prise adéquate par un électricien qualifié. Ne pas modifier la fiche.
GENERAL INFORMATION
The bag may have come dislodged in shipping. Check the bag to insure proper seating before attempting to use
the cleaner. Do not operate the cleaner without a dust bag or the filters. Damage may result to the motor (see Dust
Bag and Filter).
The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner
to avoid bag breakage, hose clogging, or possible motor damage.
DO NOT OIL the motors (in the canister and the motorized nozzle) or the brush roll at any time. The
bearings are permanently lubricated and sealed.
Customer Assistance
The instructions in this booklet serve as a guide to routine maintenance. For additional service information please
call, 1-877-207-0923. You should know the model, type and serial numbers when you call.
Rating Plate
The model, type and serial numbers are indicated on the rating plate located on the underneath side of the
cleaner. For prompt and complete service information, always refer to these numbers when inquiring about service.
Model No. & Type______________________________
Serial No._____________________________________
Automatic Motor Shut-Off
To protect from overheating, this vacuum cleaner is equipped with a thermostat which automatically shuts off the
motor if it overheats. Should this happen:
1. Turn off the switch and unplug the cleaner because the thermostat will allow the cleaner to automatically start
running again when the motor cools (approximately 30 minutes);
2. Check the hose, bag, and filters as a clogged hose, full bag, or dirty filters could cause the motor to overheat;
and
3. Call 1-800-207-0923 for customer assistance if the cleaner will not operate after cooling for approximately 30
minutes.
4