Filter
Top Products
10
8.4 Stockton 8 (7126) only, Remove the old centre strip seal
and old fixing glue from the left hand door and use a clean,
dry cloth to remove all old dust and debris.
8.5 Squeeze a generous bead of fresh Stovax Thermic Seal Glue
into the rope locating groove. Press the new Stovax rope
into the locating groove, placing the joint in the middle of
the lower edge of the door.
8.6 Stockton 8 (7126)only, apply a bead of fresh Stovax
Thermic Seal Glue to the centre seal location on the left
hand door.Press a new seal strip into position.
8.7 Refit the door and close the door to apply pressure to new
rope. Leave the stove closed for at least 12 hours before
lighting the stove and using at a low output for
approximately one day.
8.8 Using the stove with damaged door seals could cause
dangerous fumes to enter the room, or the stove to overfire,
resulting in damage.
9.1 To maintain the safe use of your Stockton, you may need to
adjust the door hinges to ensure the safe, correct closing of
the door. Complete this operation as follows.
9.2 Open the door to give access to the hinge block fixing nut.
9.3 Using a 20mm A/F spanner loosen the fixing nut inside the
stove as shown in diagram 1, and reposition the hinge
blocks to achieve a correct fit. This may need a trial and
error approach to find the correct position.
9. ADJUSTING DOOR HINGES
NOTES
MAINTENANCE AND SERVICING
Fixing Nut
Lock Nut
1