7. MAIN CONTROL ASSEMBLY
7.1 To access the main control assembly, first remove:
7.2 To remove the splitter plater:
9
AR1966
All components can be replaced without removing the
control assembly.
8. PILOT UNIT ASSEMBLY
10
AR1963
disconnect the ignition lead from the electrode
27
11
AR0097
13mm
4.0mm
sleeve which is needed for the replacement
through the vida flex and secured with a cable tie
There is a cut out in the pilot shroud to hold the vida flex.
9. IGNITION LEAD
the ignition lead from the electrode
the control box, Diagram 12
12
AR1963
with a cable tie and the red insulated end is attached to the
electrode
NOTE: DO NOT ROUTE THE IGNITION LEAD IN THE
VICINITY OF THE ANTENNA ON THE CONTROL BOX.
THIS DAMAGES THE COMPONENTS.
SERVICING INSTRUCTIONS
REPLACING PARTS