Filter
Top Products
14
6.2 Locate the rear panel against the spacer brackets and slide
down so that it locates on the ledge of the flame baffle, see
diagram 6.
6.3 Locate the front coal between the heat shield and flame
baffle so that its ends sit flat against the burner skin, see
diagram 7.
6.4 Place five of the loose round coals on the front coal so that
they lean against the flame baffle, in between the fingers.
Place the two rectangular coals behind the round coals, one
at each side, see diagram 8.
6.5 Place four of the loose round coals behind the first row so
that they sit on the fingers, the two outer coals should touch
the rectangular coals, see diagram 9.
6.6 Place the remaining three round coals behind the centre
row so that they touch the back panel, see diagram 10.
6.7
Ensure that the fibreglass seal on the back of the door is intact,
locate the door on the four studs and slide back to the firebox.
Secure in place using the four brass nuts and the tool
supplied, do not over tighten the nuts, see diagram 11. Keep
the tool with these instructions for future use.
NEVER OPERATE THE STOVE WHEN THE DOOR IS
REMOVED OR WHEN THE GLASS IS BROKEN.
INSTALLATION INSTRUCTIONS
INSTALLATION
7
8
9
10
11
AR0362
AR0363
AR0390
AR0364
6
AR0360
AR0361