Stovax 7051lG Stove User Manual


  Open as PDF
of 30
 
11
USER INSTRUCTIONS
15. SEASONAL USE
15.1 Clean and service the appliance if it is not used during the
warmer periods of the year as detailed in the Maintenance
and Servicing section
15.2 Set the air controls 50% open to keep the appliance
ventilated and stop the build-up of any moisture inside.
15.3 Before re-lighting the appliance:
•Remove the baffles
•Clear any debris that may have accumulated
•Check the flue is clear of any blockages
16. TROUBLESHOOTING TIPS
16.1 Stove glass blackening:
This has four possible causes:
1. Incorrect use of airwash – See Sections 1, 4 and 5 for the
correct use of the air controls.
2. Burning unseasoned wood – See Section 3 to identify
when wood is ready for burning.
3. Stove operated at too low a temperature - good working
temperature is 300-500° F (120 – 250° C). A stove pipe
thermometer can identify this problem (Stovax part no
3046)
•Burnwiththeairwashcontrolfullyopenfor
approximately 20 minutes to cure this
The problem may be caused by damping your appliance
down overnight.
4. Problems with the flue – in particular insufficient air pull.
If the flue is not working efficiently the glass can blacken.
A flue which has too much downdraft may be too short or
needs lining or has too many bends. This can also cause
blackening of your stove glass. Contact the installer or a flue
specialist for advice.
16.2 Riddling mechanism jamming:
This occurs when fine ash builds up under the riddling bars
preventing movement. To prevent this:
•Followaregularcleaningroutinefortheinsideofyour
appliance
•Liftouttheriddlingmechanismandremoveallash
•Replaceriddlingmechanismwhencleaningiscomplete
16.3 Glass cracking:
Do not over tighten the screws on the glass clips when
replacing the glass as this causes stress and the intense
temperature changes can cause the glass to crack. For
replacement glass contact your local Stovax dealer.
16.4 Appliance is producing tar:
This is identified by:
•Averystrongpungentsmellshortlyaftertheapplianceis
lit and heats up
•Glassblackening
•Thick,brownandstickytaroozesfromthepipejoints
This is caused by burning damp wood and burning your
appliance at too low a temperature;
•Usewellseasonedwoodandoperatetheappliancein
the ideal temperature range
Tar is a major cause of chimney fires - if you experience
problems with tar build up consult a chimney sweep before
continued use of your appliance.
Ideal working temperature range is 130°C and 240°C
(270°F – 465°F). Failing to close down the primary air
control once the appliance has heated up to this range
may cause the appliance to over-fire and to exceed the
ideal temperature range. Over-firing can cause permanent
damage to the appliance and invalidates your warranty.
 previous next