Filter
Top Products
11
GB
1. Screw telescopic pipe
ቢ
on the pump.
2.
Release clamping sleeve
ባ
of the telescopic pipe.
3. Adjust telescopic pipe stalk
ቤ
to the height of
the container. The length of the telescopic pipe
can be adjusted between 39–62 cm.
4. Tighten clamping sleeve
ባ
by hand.
The length of the telescopic pipe
ቤ
should be set
in such a way that the pump does not touch the
bottom of the container. This prevents dirt in the
container reaching the pump.
A rope must be run through the handle
ብ
of the
pump for deeper water containers (max. 1.5 m).
ቢ
ባ
ቤ
If the battery pump is used in flat containers, e.g. to empty a
paddling pool, the telescopic pipe can be removed and replaced
by the threaded tap connector supplied. The 13 mm (1/2”),
16 mm (5/8”) or 19 mm (3/4”) hose connection must be set up
using Original GARDENA System hose connections.
Setting up the telescopic
pipe on the container:
Complete Solution:
(a) the GARDENA Rain Water
Collection Filter (Art. No.
3820 / 3821)
(b) the GARDENA Connecting
Set (Art. No. 3815),
(c) the GARDENA Rain Water
Tank (Art. No. 3801 / 3805)
(d) the matching GARDENA
Cover for Rain Water Tank
(Art. No. 3800 / 3804), and
(e) the GARDENA Battery Pump
(Art. No. 1498).
Use in shallow vessels:
ብ
4. Operating
Charging the battery: The battery may only be charged using the NL-12 charger
supplied or the solar panel, Art. 7851-00.620.00 with charging
cable Art. 1498-20.600.22, obtainable from GARDENA Service.
Operating the pump is not possible during charging!
The battery is partially charged in the works for safety reasons.
The battery must be charged before it is used for the first time.
As this NiCd-battery is subject to self-discharging, the battery
must be charged up to reach a full charge if it has been stored for
a relatively long time.
Art. No. 3820/21
Art. No. 3815
Art. No. 380
1/3805
Art. No. 3800/3804
Art. No. 1498