Filter
Top Products
AR-15 VOLTAGE REGULATOR / POWER CONDITIONER
Congratulations on your purchase of a
Furman AR-15 AC Line Voltage Regula-
tor / Power Conditioner. The AR-Series
regulators are designed specifically for
any audio, video, or computer rackmount
system requiring clean, filtered, and regu-
lated AC power for optimum operation.
AR-15 FEATURES
•
Provides nine regulated, conditioned AC
outlets—eight on the rear panel and one on
the front
• Series mode protection plus (SMP+) with
extreme voltage shutdown (E.V.S.)
• LiFT (Linear Filtering Technology) with
zero ground contamination
• Eight rear panel outlets and one front
panel outlet
• BNC connector on the rear panel allows
you to attach any standard (12VAC 0.5
amp) gooseneck lamp to illuminate the
rear of your rack
•
Extreme Voltage Shutdown indicator LED
•
Output In Regulation indicator
•
Ten-LED bargraph input voltmeter
•
Fast-acting user-accessible circuit breaker
protects against overload or shorts
•
Very low stray magnetic field leakage
•
Input capacity is 15 A; output capacity is 12
to 15 A
SAFETY INFORMATION
To obtain best results from your Furman AR-15
please be sure to read this manual carefully.
WARNING: To reduce the risk of electrical
shock, do not expose this equipment to rain or
moisture. Dangerous high voltages are present
inside the enclosure. Do not remove the cov-
ers. There are no user serviceable parts inside.
Refer servicing to qualified personnel only.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of uninsulated danger-
ous voltage within the product’s enclosure that
may be of sufficient magnitude to constitute a
risk of electric shock.
IMPORTANT SAFETY
INSTRUCTIONS
PLEASE READ PRIOR TO INSTALLATION
1. Please read and observe all of the safety and
operating instructions before the AR-15 is
operated. Retain these instructions for future
reference.
2. The AR-15 should not be used near water
— for example, near a bathtub, kitchen sink, in
a wet basement, near a swimming pool, etc.
3. Do not place the AR-15 near
heat sources such as radiators,
heat registers, stoves, or other
appliances that produce heat.
4. Route the power cord and other cables so
that they are not likely to be walked on,
tripped over, or stressed. Pay particular at-
tention to condition of cords and cables at
plugs, and the point where they exit from the
AR-15. To prevent risk of fire or injury, dam
-
aged cords and cables should be replaced
immediately.
1