Filter
Top Products
En-5
OPERATION
THERMO
SENSOR
Room temperature sensor selection
Press the THERMO SENSOR button to select whether the
room temperature is detected at the indoor unit (remote
sensor) or the remote controller.
When the
thermo sensor display appears, the room
temperature is detected at the remote controller.
NOTES
• This function is locked at the factory. In order to detect the room temperature correctly, consult authorized service
personnel when using this function.
• If this function is locked, the location where the room temperature is detected cannot be changed and the
mark
flashes when the THERMO SENSOR button is pushed.
Indoor unit
ON/OFF TIMER
Instructions related to heating are applicable to “HEAT PUMP MODELS” and “HEAT RECOVERY MODELS” only.
The timer function is not available depending on the model.
To set the ON/OFF timer
Press the TIMER MODE button to
select the ON TIMER or OFF
TIMER.
2
• Press the DELETE button to cancel the timer mode.
• The timer mode can also be canceled by changing the timer mode using the TIMER MODE button.
1
CLOCK ADJUST
No display
SU
MO
TU
WE
TH FR
SA
Press the SET TIME buttons to set the time.
After the time is set, the timer will start automatically.
The amount of time until the OFF timer operates that is dis-
played on the timer display decreases as time passes.
From 1 to 24 hours
ex. OFF timer set for 6 hours
● To cancel the timer mode
DELETE
NON
STOP
OFF
TIMER
ON
TIMER
WEEKLY
TIMER
Part lock function
DAY OFF
DELETE SET
SET BACK
DAY
CLOCK ADJUST
Press the DAY (DAY OFF) button and SET button simulta-
neously for 2 seconds or more to activate the part lock
function and lock all of the buttons on the remote con-
troller except the Start/Stop button, Set Temperature but-
tons, Master Control button, and Fan Control button. Press
the buttons again for 2 seconds or more to deactivate the
part lock function.
When the part lock function is activated, the
mark
appears. If any button is pressed during the part lock, the
PL
display flashes.