Filter
Top Products
En-6
Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Remote Control Signal Receiver
4 Indicator Lights (Fig. 3)
5 OPERATION Indicator Light (red)
6 TIMER Indicator Light (green)
7 SWING Indicator Light (orange)
(VERTICAL SWING)
8 SWING Indicator Light (orange)
(HORIZONTAL SWING)
●
If the TIMER indicator light flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 15 Auto Restart).
9 Intake Grille (Fig. 4)
0 Air Filter
A UP/DOWN Air Direction Flaps
B RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
C Drain Hose
D Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
E Intake Side
F Outlet Side
Fig. 6 Remote Control Unit
G SLEEP Button
H MASTER CONTROL Button
I SET TEMP./SET TIME Buttons (
)
J Signal Transmitter
K TIMER Button
L FAN CONTROL Button
M START/STOP Button
N Battery compartment lid
Inside of the battery compartment lid (Fig. 7)
O AIR FLOW DIRECTION Button
P ENERGY SAVE Button
Q CODE CHANGE (Slide Switch)
Switching the remote control unit code.
(Max. 4 units)
R TIME ADJUST Button
S TEST RUN Button
● This button is used when installing the air
conditioner and should not be used under
normal conditions as it will cause the air
conditioner’s thermostat function to oper-
ate incorrectly.
● If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the indoor unit’s OPERA-
TION indicator light and TIMER indicator
light will begin to flash simultaneously.
● To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
T ACL Button
U Remote Control Unit Display (Fig. 8)
V Transmit Indicator
W Clock Display
X Operating Mode Display
Y Timer Mode Display
Z Fan Speed Display
[ Temperature Set Display
\ Timer Set Indicator
] Temperature Set Indicator