Filter
Top Products
En-10
ADJUSTING THE DIRECTION OF AIR CIRCULATION
Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).
Start air conditioner operation before performing this procedure.
* Press the START/STOP button to start the air conditioner, and then
proceed as follows.
Press the VERTICAL AIRFLOW DIRECTION and SWING button to adjust the
direction of the vertical airfl ow.
To set the operation mode
●
Vertical air direction adjustment
Airfl ow Direction Setting:
1
,
2
,
3
,
4
: During Cooling/Heating/
Dry mode
●
The vertical airfl ow direction is set automatically as shown, in accordance with the
type of operation selected
.
During Cooling/Dry mode : Horizontal fl ow
1
* During Heating mode : Downward fl ow
4
●
During AUTO mode operation, for the fi rst minute after beginning operation, air-
fl ow will be horizontal
1
; the air direction cannot be adjusted during this period.
●
Horizontal air direction adjustment.
The function cannot be used.
●
Attempting to move up/down air di-
rection flaps manually could result
in improper operation; in this case,
stop operation and restart. The
louvers should begin to operate prop-
erly again
.
●
When used in a room with infants,
children, elderly or sick persons, the air
direction and room temperature should
be considered carefully when making
settings
.
Each time the button is pressed, the air direction range will change as follows:
1
2
3
4
The remote controller’s display does not change.
SWING OPERATION
Begin air conditioner operation before performing this procedure.
Press the VERTICAL AIRFLOW DIRECTION and SWING button for more
than 2 seconds. (Stop the setting by pressing for more than 2 seconds again.)
To select/stop swing operation
●
The SWING operation may stop temporarily when the air
conditioner’s fan is not operating, or when operating at very
low speeds.
About Swing Operation
The type of operation
Cooling/Heating/Dry/Fan
Range of swing
1
to
4