En-4
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
●
When kept on pressing the MANUAL
AUTO button for more than 10 sec-
onds, the forced cooling operation will
start.
●
The forced cooling operation is used at
the time of installation.
Only for authorized service personnel's
use.
●
When the forced cooling operation
starts by any chance, press the START/
STOP button to stop the operation.
●
Please press the button at
FILTER
INDICATOR RESET
3
Indicator (Fig. 3)
4
Remote Control Signal Receiver
5
OPERATION Indicator Lamp (green)
6
TIMER Indicator Lamp (orange)
●
If the TIMER indicator lamp flashes
when the timer is operating, it indi-
cates that a fault has occurred with the
timer setting (See Page 17 Auto Re-
start).
7
ECONOMY Indicator Lamp (green)
●
ECONOMY indicator lamp lights when
ECONOMY OPERATION and MINIMUM
HEAT OPERATION is operating.
8
Intake Grille (Fig. 4)
9
Front Panel
0
Air Filter
A
Airfl ow Direction Louver
B
Right-Left Louver
(behind Airfl ow Direction Louver)
C
Drain Hose
Fig. 5 Remote Controller
D
Signal Transmitter
E
MODE button
F
MIN.HEAT button
G
ECONOMY button
H
SLEEP button
I
TIMER MODE button
J
FAN button
K
START/STOP button
L
SET button (Vertical)
M
SWING button
N
SET TEMP. button (
/ )
O
TIMER SET ( / ) button
P
CLOCK ADJUST button
Q
TEST RUN button
●
This button is used when installing
the air conditioner, and should not be
used under normal conditions, as it
will cause the indoor unit’s thermostat
function to operate incorrectly.
●
If this button is pressed during normal
operation, the indoor unit will switch
to test operation mode, and the Indoor
Unit’s OPERATION Indicator Lamp and
TIMER Indicator Lamp will begin to
fl ash simultaneously.
●
To stop the test operation mode, press
the START/STOP button to stop the air
conditioner.
R
RESET button
S
Remote Controller Display(Fig.6)
T
Temperature SET Display
U
Operation Mode Display
V
SLEEP TIMER Display
W
Transmit Indicator
X
Fan Speed Display
Y
SWING Display
Z
Timer Mode Display
[
Clock Display