Filter
Top Products
7
Operating Instructions
2009 Electrolux Home Products, Inc. All rights reserved.
Removing Collected Water
1. Emptying the Bucket:
a. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate.
b. Do not move the unit at this time otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.
e. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.
f. You should hear a click when the bucket is in the correct position
Discard water from bucket. Water is not potable and cannot be used for drinking.
WARNING
If the bucket full light does not extinguish, check that the float is correctly snapped in place as indicated by the diagram.
The foam embedded under the float(shown in the diagram below) is a functional part, which can not be removed.
NOTE:
Foam