Filter
Top Products
5
Front Installation
Some models are shipped in a removable sleeve, please follow the supplied
Installation Instruction before installing the Decorative front and accessories.
Installing the Vent Control (on some models)
The vent control handle is included in the decorative front kit. The handle must be
installed before the decorative front is attached.
1. Insert the handle with the “etchings (Vent/Air)” facing to the left.
2. Slip the black door extension into the split at the end of the handle.
3. For ease of assembly, push the handle in while pressing the door extension
against the foam until the two pieces lock together.
4. Move handle in and out to be sure vent is operating properly.
Installing the Front Frame
Some models require installation of the front panel of the air conditioner included
in a decorative kit. To assemble, follow these steps. Before installation, remove the
tilt panel from the frame. Grasping the panel from both sides, gently pull to release,
then lift panel from pivot points at bottom of frame).
STEP 1: INSTALL DECORATIVE FRONT TO CABINET:
Decorative Front
• Loosen the screw to the left of the Electronic Control by 1/2 turn to easily
install the decorative front.
• Position the top of the decorative front over the top flange of the case, and
align the tabs with the slots in the case (Fig. 1).
• As you install the front frame to
the unit be sure the vent handle is
positioned through the front in
the proper location (Fig. 2).
• Carefully pull down on the front
to engage the top tabs, while
pushing the front over the case to
ensure proper alignment.
• The side tabs will “click” when
front is seated.
• Install front retaining screw(s)
behind the filter and panel
(Fig. 2 & 3).
• Then add filter and front panel.
• Install behind the filter handle.
FIG. 1
FIG. 3
FIG. 2