Filter
Top Products
4
Operating Instructions
Using Air Conditioner
To begin operating the air conditioner, follow these steps:
Set the temperature selector to the highest number (coldest or coolest setting).
Set the mode control to the highest COOL setting.
Adjust the louvers for comfortable air flow (see Air Directional Louvers).
Once the room has cooled, adjust the temperature selector to the setting you
find most comfortable.
Review the “Operating Instructions” section for other settings.
Operating Instructions
The controls featured in this manual are representative of many available
models. Your model may offer slightly different features.
This is used to set the desired room temperature when the unit is being
operated in the “COOL MODE”.
To set the desired room temperature, rotate the selector switch to the desired
setting. After the set temperature is achieved, the thermostat will automatically
start and stop the compressor in order to maintain the desired set temperature.
Rotate the temperature selector clockwise for higher cool setting. Higher cool
settings will provide lower room temperature.
Rotate the temperature selector counter-clockwise for lower cool settings.
Lower cool settings will provide higher room temperature.
Temperature Selector
Cool Mode
The desired cool setting is selected by rotating the MODE knob to the appropriate location.
“High Cool” has maximum cooling effect and airflow.
“Med” has the intermediate cooling effect and airflow.
“Low Cool” has minimum cooling effect and airflow.
Note:If your unit is equipped with a vent handle, keep it closed for maximum efficiency.
Fan Mode
Rotate the MODE knob to the left to select your choice of fan speeds for air circulation.
Note: When selecting a fan speed, the compressor will not run. On models with a vent
control, this mode can be used to remove stale air from the room, or to draw fresh air
into the room. Check the section ‘Additional Things You Should Know’.
WARNING
Please always wait 3 minutes when turning unit off then on again, and when changing from cool to fan and back to
cool. This prevents compressor from overheating & possible circuit breaker tripping.
Failure to follow these instructions may be harmful to your unit.
2009 Electrolux Home Products, Inc. All rights reserved.