Filter
Top Products
7
920-197-01
Sash window installations
STEP 1 After removing the unit from shipping carton, remove tape holding
decorative front in place. Lay front in a safe out-of-the-way place, then
slide chassis out of cabinet (see Figure A).
STEP 2 Attach curtain assemblies to cabinet as shown in Figure B. Use eight
(8) No. 8 x
" slotted hex head screws (item #1, page 6).
STEP 3 Center cabinet in window with sill channel positioned against
window stool as shown in Figure C, Section A-A.
STEP 4 Pull window sash down behind Shell Support Channel on top of
cabinet; this helps hold cabinet in place. Install No. 8 x
"hex
head screw (item #3, page 6) in sill channel at bottom of window
opening as shown in Figure C.
STEP 5 Extend the sliding curtains on each side so the frames ¿t into
the window channels. While holding the curtainframes in place,
mark four (4) hole locations (hole locations are in the upper
corners on left and right curtain assembly), two (2) in the
window jamb and two (2) in the window sash. Slip the curtains
back from marked locations and drill four (4)
7
/
64
" diameter pilot
holes. Again,
extend the sliding curtains on each side and then
install two (2) no.8x½"Phillips head screws (item #2, page 6)
andtwo(2)No.8x1¼"Phillips head screws (item #4) through
the curtain frames as shown in Figure C.
Figure A
BASEPAN HANDLE
PULL STRAP
TOPULLUNITFROMSLEEVE,USEPULL STRAP ANDBASEPAN
HANDLELOCATEDONFRONT.OBTAINASSISTANCEORHELP
ASNECESSARYTOHOLDSLEEVEWHILEPULLINGUNITFROM
SLEEVE.MAKESUREAIRCONDITIONERISON FIRMSUPPORT
BEFOREREMOVINGUNIT FROMSLEEVE.
WHEN CARRYING OR HANDLING UNIT, OBTAINASSISTANCE OR
HELPAS NECESSARY TO SUPPORT UNIT FROM BOTTOM (BASE
PAN), MAINTAINING CLEARANCE FROM ALL OBSTACLES.
CURTAIN
ASSEMBLY
RETAINING
BRACKET
CURTAIN
ASSEMBLY
(LEFT)
SHELL SUPPORT
CHANNEL
Figure B
SCREW #8 x "SLOTTEDHEXHEAD
(ILLUSTRATION ON PAGE 6, ITEM #1)
8REQUIRED(4EACHSIDE).INSTALL
FROMINSIDESLEEVETOCURTAIN
ASSEMBLY RETAINING BRACKET
CURTAIN
ASSEMBLY
(RIGHT)
Figure C
SECTION A-A
SCREW, 1/2”PHILLIPS HEAD
(Seeillustration, item#2,page 6)
SCREW, 11/4”PHILLIPSHEAD
(Seeillustration, item #4, page6)
SCREW, #8 x 7/8”HEXHEAD
(Seeillustration, item#3,
page 6)
WINDOWSTOOL
SILL
CHANNEL
SHELLSUPPORTCHANNEL
WINDOWSASH
CABINET
Falling Object Hazard
Not following Installation Instructions
for mounting your air conditioner can
result in property damage, injury, or
death.
WARNING
Cut/Sever
Although great care has been
taken to minimize sharp edges
in the construction of your unit,
use gloves or other hand
protection when handling unit.
Failure to do so can result in minor
to moderate personal injury.
CAUTION
Excessive Weight Hazard
Use two or more people when
installing your air conditioner.
Failure to do so can result in
back or other injury.
CAUTION