Filter
Top Products
6
920-115-05 (11-04)
To adjust temperature
5 WARMER - Press the TEMP button to raise the
temperature setting.
6 COOLER - Press the TEMP button to lower the
temperature setting.
To adjust fan speed
7 FAN SPEED - Press the FAN SPEED button to see
the current setting. Press again to change the fan
speed. F1 is the lowest setting (SLEEP / LOW), F2 is
MEDIUM, F3 is HIGH, and SF is the SMART FAN
setting.
To set the hour clock
8 SET HOUR CLOCK - Press SET HOUR once to
see the current clock setting. Continue pressing the
button until you arrive at the current time (Hour only).
Minutes are not shown on the display. Make sure that
the A.M. / P.M. setting is correct.
To set the timer
NOTE: You can set the START and STOP times a minimum
of one hour apart, and a maximum of 23 hours apart.
9 TIMER START - Press START to view the current
start time for cooling. Continue pressing the START
button until you arrive at the start time you desire. The
start time for cooling will then be set.
10 TIMER STOP - Press the STOP button. Continue
pressing the STOP button until you arrive at the stop
time you desire. The stop time for cooling will then
be set.
11 TIMER ON / OFF - Press the TIMER ON / OFF but-
ton to activate (light on) or deactivate (light off) the
timer. Once the on and off times have been selected,
they will remain in memory and cycle daily until
changed.
NOTE: If the unit is unplugged or the power is inter-
rupted, the SET HOUR function must be reset or the
TIMER ON / OFF function will not work.
Additional RC1 wireless remote controls can be purchased
from your Friedrich dealer.
How to use the remote control
To start unit
1
POWER - Press the POWER button once. The unit
will automatically start in the mode and fan speed it
was last left on.
To set mode of operation
2
COOL - Press the COOL button to automatically
switch the operating mode to COOL.
3
FAN ONLY - Press the FAN ONLY button if you want
to run the fan only. You may want to use this feature
in conjunction with the EXHAUST if you want to
exhaust stale air. (The EXHAUST feature is located
on the upper right side of the electronic control center
on the air conditioner). See page 4, Figure 3.
4
MoneySaver
®
- Press the MoneySaver
®
button to ac-
tivate the MoneySaver
®
feature. MoneySaver
®
is the
feature that cycles the fan with the compressor so that
the fan does not run all the time.
Money
Fan
Timer Operation
Set Hr.
Stop
Start
Temperature
Fan
Cool
On/Off
POWER
Cooler
Warmer
Only Speed Saver
®
8
10
4
7
1
11
9
3
2
5
6
Figure 4