Filter
Top Products
4
920-007-12
To start unit
If your air conditioner is installed and plugged into a proper re cep ta cle,
it is ready to go. The fi rst time the unit is started, the compressor will
delay for three minutes. See Automatic Component Protection on the
following page.
1
Touch the Power button once. The unit will automatically be in
Cool mode with the temperature set at 75
°
F (24
°
C) and the fan
speed at F1, the sleep setting.
To set mode of operation
When you fi rst turn the unit on, it will be in the Cool mode (light on)
with constant fan.
2
Touch the Mode button once to activate the MoneySaver
®
(light on).
MoneySaver
®
is a feature that cycles the fan with the
com pres sor so that the fan does not run all the time. This saves
energy and improves de hu mid i fi ca tion. MoneySaver
®
will also
run to test the temperature if the off cycle is too long. Or you
may prefer con stant fan for more air move ment. (To return to
constant fan, touch the Mode button two more times).
In order to run the fan by itself, do the following:
3
Continuing from MoneySaver
®
mode (light on), touch the Mode
button once to activate the Fan Only feature (light on).
The Fan Only setting will circulate air in the room without the
compressor coming on.
72
How to operate your Friedrich room air con di tion er
Figure 2
WS mod els
Figure 1
Temp/Hour
Cool
MoneySaver
®
FanOnly
Clock
StartTime
StopTime
Power
Fan
Speed
Mode
PM
Timer
On/Off
Set
Hour
72
2 3 4
8
9
10 11 12
13
1
6
5
7
Model Plug Type
Circuit Rating, Breaker
or Time Delay Fuse
WS08, WS10, WS14 NEMA No. 5-15P 125V-15 AMP
WS10, WS13, WS16 NEMA No. 6-15P 250V-15 AMP