Friedrich WS08B10A Air Conditioner User Manual


  Open as PDF
of 6
 
USC Sleeve/Standard Grille USC Sleeve/Replacement Grille*
STANDARD GRILLE – Expanded aluminum
For use with USC sleeve. (Ships with USC sleeve).
*REPLACEMENT GRILLE – High-tech plastic
For use on existing sleeves without any grille. (Ships with
chassis).
IMPORTANT NOTE:
When installing into an existing sleeve, consult Installation
Section of your Installation/Operation Manual to determine
whether or not the grille needs to be replaced and/or a
bae adapter should be used.
Installation Accessories (WallMaster only)
DK / Drain Kit
Installed at the back of the unit and allows
for attachment to permanent condensate
disposal system, if disposal is necessary
or desired.
SB / Sub Base
Used as a base for the unit when
it is desired to place the cord and
receptacle within the installation, or
simply as a base for the unit when
mounted low in the wall.
BAK / Bae Adapter Kit
Necessary when installing in a sleeve
deeper than 16 3/4" deep, such as
Fedders B sleeve (19 3/4" deep).
IDK / Internal Drain Kit
New construction applications where
a condensate drain system has been
built into the wall interior.
16 3/4"
Fedders B
19 3/4”
IMPORTANT:
Operating the air conditioner
with incorrect rear grille or
without Bae Adapter Kit
(on 19 3/4” deep sleeve) will
recirculate discharge air and
cause compressor overload
to trip.
CORRECT Vertical Louvers
INCORRECT Horizontal Louvers
WSC Sleeve/Standard Grille WSC Sleeve/Optional Architectural Grille, AG
Model Height Width Depth
Depth
with
Front
Minimum
Extension
Into Room
Minimum
Extension
Outside
Thru-the-wall
Finished Hole
Height Width
WALLMASTER
WSC Sleeve
Chassis
16 3/4" 27" 16 3/4" 23" 7 1/2" 9/16" 17 1/4" 27 1/4"
15 3/4" 26 1/2" 21" – – – – –
UNI-FIT
USC Sleeve 15 1/2" 25 7/8" 16 3/4" 20 1/2" – 1/2" 15 3/4" 26 1/8"
US Chassis 14 3/8" 24" 20 1/8" 3 3/4" – – –
UE Chassis 14 3/8" 24 5/8" 19 5/8" 3 1/2" – – –
IMPORTANT:
• Sleeves are sold and shipped separately to accommodate
new construction and replacement requirements
Sleeve/Chassis Dimensions
Exterior Grilles
Exterior Grilles
When should you
install a solid side
sleeve?
SOLID SIDE wall sleeve
allows for installation in thick
exterior walls where the
installation of room air units
with side vents would eect
performance and may even
void the warranty.
Commercial
and residential
applications
ROOM AIR CONDITIONER
Blocked side vents restrict air ow
FRIEDRICH THRU-THE-WALL
Solid-side sleeve (no side vents)
 previous next