Filter
Top Products
6
Operating Instructions
F1 LOW
F2 MED
F3 HIGH
REMOTE CONTROL SIGNAL
RECEIVER
POWER
MODE
-
Push this button to shift mode of operation from COOL
→ MONEY SAVER → FAN.
- COOL :
• Fan runs continually for normal cooling operation.
- MONEY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on
and the unit will check the room air to determine if cooling is needed.
- FAN :
• Fan-only operation.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of
hours until shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 2°F after 30 min.,
and once again after another 30 min.
• Push Timer button to advance setting from
1 Hour
→
2 Hours
→
....
→
12 Hours maximum.
- START TIME
• If unit is off, use Timer to set number of hours
before unit starts.
• Push Timer button to advance setting from
1 Hour
→
2 Hours
→
.....
→
12 Hours maximum.
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range
of 60°F to 86°F by increments of 1°F.
• The setting appears in the display.
• To turn the air conditioner ON, push this
button.
To turn the air conditioner OFF, push the
button again.
• This button takes priority over any other
button.
• When you first turn it on, the unit is in
cool mode, at High fan speed, and set at
a temperature setting of 72°F.
FAN SPEED
• Every time you push this button, it
advances the setting as follows:
{High → Low → Med → High}
Operating Instructions
Controls
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its previous setting.