Filter
Top Products
7 Room Air Conditioner
Operating Instructions
Controls
FAN SPEED
Every time you push this button,it advances the setting as follows:{High[F2] Low[F1]} High[F2]
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
Use this button to automatically control the
temperature of the room
The tmeperature can be set within a range of
60 F to 86 F by increments of 1 F.
The setting appears in the display.
POWER
To turn the air conditioner ON,push this button.
To turn the air conditioner OFF,push the button
again.
This button takes priority over any other button.
TIMER
SHUT-OFF TIME
You will usually use shut-off time while you sleep.
If unit is running,use Timer to set number of hours until shut-off.
For your sleeping comfortonce Timer is setthe Temperature
setting will raise 2 F after 30 minand once again after another
30 min.
Push Timer button to advance setting from 1Hour→
2Hour →...
→12Hours maximum.
START TIME
If unit is off,use Timer to set number of hours before nuit starts.
Push Timer button to advance setting from 1Hour→
2Hour →...
→12Hours maximum.
MODE
Push this button to shift mode of operation from COOL → MONEY SAVER→ FAN ONLY→HEAT
COOL:
Fan runs continually for normal cooling operation.
MONEY SAVER:
The fan stops when the compressor stops cooling.Approximately every 3 minutes the fan will turn on and the nuit will
check the room air temperature to determine if cooling is needed.
FAN ONLY:
Fan-only operation.
HEAT:
Fan runs continually for normal heating operation.
AUTO RESTART
When power is restored after an electrical power failure,the unit will begin to run at its last setting.