Filter
Top Products
4
920-090-05 (10-04)
To start unit
1
If your air conditioner is installed and plugged into
a proper re cep ta cle, it is ready to go. Touch ON/OFF
button once. The unit will automatically be in COOL
mode with the temperature set at 75°F (24°C) and the
fan speed at F1, the sleep setting. There is a 3-minute
delay before the compressor will turn on. (See next
page, "Automatic Component Protection.")
2
Should the FILTER ALERT light turn on when you
fi rst turn on the unit, touch FILTER ALERT to turn
off the light.
FILTER ALERT light will come on af ter 250 hours
of use. (See page 7 for fi lter clean ing in struc tions.)
Touch FIL TER ALERT to reset.
To set mode of operation
3
When you fi rst turn on the unit, it will be in the COOL
mode (light on), with constant fan.
How to operate your Friedrich room air con di tion er
4
Touch MoneySaver
®
(light on) to activate the
MoneySaver
®
feature.
MoneySaver
®
is a feature that cycles the fan with the
compressor so that the fan does not run all the time.
This saves energy and improves de hu mid i fi ca tion.
MoneySaver
®
will also run to test the temperature if
the off cycle is too long. Or you may prefer constant
fan for more air movement. To return to constant fan,
touch COOL.
5 Touch FAN ONLY (light on) if you want only the
fan to run. You may want to use this feature in
conjunction with the FRESH AIR / EXHAUST
lever to bring outside air into a room, or to exhaust
stale air. (See page 7, "Fresh Air and Exhaust
Control" for more information.)
11
9
13
6
3
1
DISPLAY
8
5
4
2
12
15
14
10
7
Figure 3