Filter
Top Products
33
OPTIONAL: e ti taht os droc ylppus eht selbmessa yrotcaf ehT xits the left
side of the unit at the bottom. At the consumer’s discretion,
To do this, route the supply cord to the right side. Pull the
supply cord taunt through the loops (Refer to Cord Routing
Change, Figure 31) and route the cord down.
STEP 13.
STEP 14. Refer to the Control Panel Operation section for instructions.
STEP 15. You are now ready to control the c
omfort level of the room.
Use Tool Provided
Please use the provided tool to attach the decorative front to the chassis.
Figure 29
FRR024
NOTE: WHEN INSTALLING THE CHASSIS
SEAL GASKET; BEGIN AT EITHER BOTTOM
CORNER AND GO UP THE SIDE & ACROSS
THE TOP & DOWN THE OPPOSITE SIDE.
POWER CORD
CLIP
CHASSIS SEAL
GASKET (ITEM 13)
Figure 30
B
USE HAND TOOLS
DO NOT OVER TIGHTEN
LOCATION OF GRILLE
REMOVAL TOOL
FRR053
To attach and prevent damage to the front grille align the
cord notch over the cord and center the fresh air lever, then
align and tighten the four (4) captive screws as indicated by
the arrows in Figure 29. Before closing the front panel, be
sure the filter is in place. Make sure curtains do not block
the side air intakes.
the supply cord can be routed to exit the right side of the unit.