Filter
Top Products
30
Cord Routing Change
FRR054
NOTE:
DECORATIVE FRONT REMOVED USE TOOL PROVIDED.
(SEE FIGURE 28 FOR LOCATION OF TOOL).
ELECTRICAL
CONTROL PANEL
Figure 30
Remove 3 screws as shown from the electrical control panel. Save to
reinstall later.
FRR055
ELECTRICAL CONTROL
PANEL SCREWS (3)
Figure 31
STEP 16. Carefully pull out electrical control panel 1", but not all the way.
FRR056
1 INCH
Figure 32
STEP 17. Pull electrical cord strain relief downward until free and rotate
90 degrees to the right.
FRR057
ELECTRICAL CORD
STRAIN RELIEF
90°
Figure 33
STEP 18. Push electrical cord strain relief back upward into the electrical
control panel.
FRR058
ENSURE THE ELECTRICAL CORD STRAIN RELIEF IS
FLUSH WITH THE TOP OF ELECTRICAL CONTROL PANEL
Figure 34
Unplug unit.
WARNING
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner’s
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong oulet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
For convenience and optimum appearance the direction that the power cord
exits the unit may be changed from left to right by following the procedure
below. Select the exit location on the left or right based on proximity to
the power outlet.