Filter
Top Products
WALL SLEEVE
PDXWS
Galvanized steel is prepared in a
state-of-the-art, multistep process
for stronger paint adhesion, then
powder coated with a polyester
finish and cured in an oven for
exceptional durability. The wall
sleeve is insulated for thermal
efficiency. 16" x 42" x 13 ¾"
STANDARD GRILLE
PXGA
Standard, stamped, anodized
aluminum to resist chalking
and oxidation.
DEEP WALL SLEEVE
EXTENSION
PXWE
A four-inch deep, anodized
aluminum extension that attaches
to the outside of the wall sleeve
when the wall is greater than
13 ¼ inches thick (11 ¾" when a
subbase is used, and 12 ¼" when
a lateral duct is used).
DIGITAL REMOTE
THERMOSTATS
RT4
Digital, single stage thermostat.
Hard wired with single speed fan.
RT5 Digital, single stage thermo-
stat features high/low fan speed
switch. Thermostat is hard wired
and can be battery powered or unit
powered. Features backlit display
and multiple configuration modes.
Mounts to wall for control of unit.
REMOTE THERMOSTAT
ESCUTCHEON KIT
PDXRT
Kit contains ten escutcheons that
can be placed over the factory
control buttons when a remote
wall mounted thermostat is
used. The escutcheon directs the
guest to the wall thermostat for
operation and retains the LED
window to display error codes and
diagnostic information.
REMOTE CONTROL
PDXRC
One hand-held remote for control of
PTAC unit. 2008 models only.
SLEEVE EXTENSION
RETROFIT KIT
PXSE
2 ¼" sleeve extension attached
to the room side of the sleeve
to allow for the installation of a
PD-series Friedrich PTAC in a 11 ½"
deep T-series sleeve.
ARCHITECTURAL GRILLES
Architectural grilles that con-
sist of heavy gauge 6063-T5
aluminum alloy
PXAA Clear extruded aluminum.
PXBG Beige acrylic enamel.
PXSC Available in custom colors.
DECORATIVE SUBBASE
PXSB
Provides unit support for walls
less than six inches thick. Includes
leveling legs, side filler panels
and mounting brackets for elec-
trical accessories. Accepts circuit
breaker, power disconnect switch
and conduit kit.
CONDENSATE DRAIN KIT
PXDR10
Attaches to the bottom of the
wall sleeve for internal draining
of condensate or to the rear wall
sleeve flange for external drain-
ing. Recommended for all units
to remove excess condensate.
Packaged in quantities of ten.
CONDUIT KIT WITH
JUNCTION BOX
PXCJ
Hard wire conduit kit with junction
box for 208/230V and 265V units
(subbase not required). Kit includes
a means of quick disconnect for
easy removal of the chassis.
*Required for 265V installations.
POWER CORD RETROFIT
PXPC 15/20/30
Replaces LCDI power cord on 230V
models when unit is used with
a subbase. PXPC15 is used with
15 amp (0 kW and 2.5 kW) units.
PXPC20 is used with 20 amp (0 kW
and 3.4 kW) units. PXPC30 is used
with 30 amp (5.0 kW) units.
ptac optional accessories
PXAA