Filter
Top Products
9
Installation
Selection of installation location
Put the portable air conditioner in a fl at location where the air
outlets cannot be covered up, place the unit no less than 20 in.
(50 cm) away from a wall or other obstacle.
22 inch
18 inch
Mounting the intake and exhaust hoses
1) Fit one end of the exhaust hose to the exhaust terminal of
the unit then rotate it 2 - 3 revolutions to tighten the hose into
the terminal.
2) Put the other end (discharge) to the nearest window.
3) Install the intake hose in the same manner
Note: The length of the air intake and exhaust hoses are be-
tween 24" - 72". Try to keep the hose as straight and horizontal
as possible.
Air
intake
terminal
Air intake hose
Air exhaust terminal
Instructions to install hose
If the hose becomes disconnected from the hose fi tting it must be
reinserted. Fit the hose to the hose fi tting then rotate it 2-3 revolu-
tions to tighten the hose into the fi tting. See fi gure below:
Correct mounting shown below
(If mounting in the wall, the height of the hole should be 16" - 51")
Troubleshooting
Self diagnosis function
The following error codes are pre-programmed into each unit to
help identify possible unit conditions.
Failure code Diagnosis of Malfunction
E2 Room Temperature sensor failure
E3 Coils sensor failure
E4 Unit malfunction
E5 Water level exceeded capacity